Applying a Pre-Emergent Crabgrass Preventer With a Push Broadcast Spreader: Wait for 50 to 55 Degree Soil, Not a Calendar Date
Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.
A crabgrass preventer only works if it is in the soil before the seed sprouts. I time it by soil temperature, not by the first warm afternoon, and I keep fertilizer off that same pass unless the timings actually line up.
Apply a pre-emergent crabgrass preventer when the 1-inch soil temperature holds at 50 to 55 degrees Fahrenheit for several days, before it reaches 60 degrees. Use the label rate, spread it evenly, and water it in if the label says to. Do not go by a calendar date, and do not assume a fertilizer-plus-preventer bag is timed for both jobs.
What the crabgrass guides say
University of Missouri Extension's guide to spring pre-emergent herbicides says crabgrass germinates when the mean soil temperature at a 1-inch depth reaches 60 degrees Fahrenheit or above for several days. It says the product is most effective when that 1-inch mean holds at 50 to 55 degrees for five days in a row. It also says a split application of the recommended amount, 30 to 45 days apart, lasts longer than one full dose, and that two-way granular products that mix fertilizer with a pre-emergent are not recommended, because cool-season lawns in Missouri need spring fertilizer in May, later than the preventer window.
University of Minnesota Turfgrass Science's guide to spring pre-emergent applications says not to rely on a calendar date, because germination is driven by soil temperature. It says pre-emergent herbicides for crabgrass should be applied before soil temperatures are 55 degrees in the upper 1 to 2 inches for several days. It also says fertilizer-plus-preventer products can make timing harder, because preventers often need to go down from mid-April to mid-May, while fertilizer is better when the lawn is actively growing from mid-May to early June.
Timing and spreading
- Check 1-inch soil temperature in the morning for several days, in a bare or short-turf spot that represents the lawn.
- When that reading holds near 50 to 55 degrees Fahrenheit, apply a pre-emergent labeled for home lawns, at the label rate.
- Calibrate the spreader the same way you would for fertilizer, and split the load for two perpendicular passes if the label allows a split or a half-rate grid.
- Keep the hopper shut over flower beds, vegetable gardens, and any area you plan to seed soon, because many preventers also stop grass seed.
- Water the product in if the label requires it, so the barrier forms in the top of the soil.
- If you are splitting the application, mark the date and put the second half down 30 to 45 days later, still at the label rate.
A push broadcast spreader lays down a uniform barrier on an open lawn if you walk a steady grid and do not leave skips. Crabgrass finds those skips first.
The classic mistake is waiting until you see green clumps in the driveway cracks. By then the seed has already germinated, and a pre-emergent will not fix plants that are already up.
Gear and next steps
Harbor Freight and Home Depot both sell an inexpensive soil thermometer, which is more useful here than a calendar reminder. I keep the lawn edged and dense, because a preventer is only one part of keeping crabgrass from moving in.
This walkthrough on popping dandelions out of the lawn with a hori hori knife is the follow-up for broadleaf weeds that a pre-emergent will not finish off once they are growing.

Comments
Post a Comment