Cutting Bent Wire Stays Out of a Wildlife-Friendly Barbed Fence With a Bolt Cutter: Why Collapsed Stays Trap Deer and Elk
Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.
Wire stays are meant to keep fence strands evenly spaced. Once they get bent over, they pull the strands together and turn a fence wildlife can jump into one that catches legs.
Wire stays bend easily and can collapse a fence, pulling the top wires close enough to tangle a deer or elk. Cut out bent wire stays, keep at least 12 inches between the top two wires, and replace the stays with stiff plastic or composite ones if you need them at all.
What the wildlife guides say
Montana Fish, Wildlife and Parks' landowner's guide to wildlife friendly fences says wire stays are easily bent over, collapsing the fence and raising the chance of entanglement. It says to preferably use no vertical stays, and if you do, to use stiff plastic or composite stays or regularly maintain wire ones.
The same guide asks for at least 12 inches between the top two wires and posts at 16.5-foot intervals. Deer and elk easily tangle their back legs when the top two wires are too close.
The Wyoming Game and Fish guide to fences and wildlife carries the same advice. It points to stiff plastic or composite stays, or fiberglass posts that flex but hold their shape.
Cutting out the bad stays
- Walk the line and flag every stay that is bent or pulling wires together.
- Wear heavy gloves and eye protection.
- Cut the stay's wraps at each strand, starting from the top.
- Pull the stay out and coil it to haul off.
- Re-space the strands so the top two are at least 12 inches apart.
A 24-inch bolt cutter cuts the twisted wraps on old stays cleanly. The long handles give leverage on rusted wire.
The classic mistake is straightening a bent wire stay and leaving it. It folds over again in the next heavy snow or when an animal hits it.
Gear and next steps
Tractor Supply carries composite fence stays and fiberglass posts that hold their shape. Buy enough to replace every stay you cut.
If a strand breaks while you work, this walkthrough on splicing a broken woven wire line wire shows the fix.

Comments
Post a Comment