Cutting High-Tensile Fence Wire Safely With a Bolt Cutter: Release the Tension First, Gloves and Eye Protection On

Gloved hands with bolt cutter at slack high-tensile fence wire

Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.

High-tensile wire stores a lot of energy when it is tight. Cut it wrong and the loose end can whip back toward whoever is holding the cutter.

Before cutting high-tensile wire, back off the in-line strainer so the strand is slack, then cut. Wear heavy gloves and eye protection, stand to the side of the wire, and hold the free end while you cut so it cannot spring back.

What the fence guides say

Virginia Cooperative Extension's guide to constructing high-tensile wire fences says to always wear heavy gloves and eye protection when tensioning wire. The same care applies when cutting it.

The British Columbia four-strand fence specifications call for 12 1/2-gauge galvanized wire on metal post fences. Wire that heavy carries real tension when it is strung tight.

Releasing the tension

  1. Find the in-line strainer or tightener on the strand you are removing.
  2. Back it off slowly until the wire hangs slack between posts.
  3. If there is no strainer, clamp the wire with a fence stretcher on the post side so you can let it out under control.
  4. Check that the next span is slack too before you make the cut.

Making the cut

  1. Put on heavy leather gloves and safety glasses.
  2. Stand to the side of the wire, never in line with it.
  3. Grip the wire on the free side of the cut.
  4. Close the jaws in one firm squeeze and let the end out slowly.

A 24-inch bolt cutter cuts 12 1/2-gauge wire in a single stroke. The long handles keep your face farther from the cut.

The mistake that costs most people a scare is cutting a tight strand in the middle of a span. Both ends snap back toward the posts at once.

Gear and next steps

Tractor Supply stocks safety glasses, leather gloves, wire stretchers, and spools for rolling up old wire. Coil cut wire right away so it does not tangle in the grass.

If you are taking out an old fence or a hot line, this walkthrough on finding a short in a buried undergate cable helps when the rest of the system still needs to run.

Comments

Popular posts from this blog

Hardware Cloth Guide: Mesh Sizes, Gauges, and Which Build Each One Fits

How to Attach Hardware Cloth to Wood Frames (Staple, Screw & Batten Spec)

How to Attach Hardware Cloth to Metal T-Posts and Pipe Frames (Tie & Clamp Spec)