Cutting Wire-in-Hose Guying Off a Young Tree With a Bolt Cutter: Remove It After One Growing Season Before It Girdles the Trunk

Bolt cutter snipping wire at a stake beside a young tree

Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.

Wire threaded through garden hose is still a common way to stake a new tree. Left on too long, it squeezes the trunk and can grow right into the bark.

Remove tree stakes and their wire after one growing season. Cut the wire at the stake, not against the trunk, then unwrap the hose loop carefully so you do not tear the bark. If wire has grown into the trunk, cut it flush and leave what is buried.

What Extension says

Colorado State University Extension's staking trees page says wire threaded through hose concentrates pressure, causing girdling and other damage. It says stakes should be removed after one growing season because forgotten stakes cause long-term damage.

The CSU page also says staking can damage the trunk as soon as six months after planting. Materials left on can girdle or grow into the tree and create weak points.

University of Minnesota Extension's staking and guying guide says wire in hose can cause compression or girdle the tree if left on too long. It recommends webbing to protect the trunk on larger trees.

Taking it off

  1. Check the trunk at the hose loop for squeezing or swollen bark.
  2. Cut each wire at the stake end, well away from the trunk.
  3. Unwrap the hose loop by hand, easing it off rather than pulling.
  4. Where wire has grown into the bark, cut it flush on both sides and leave the buried section.
  5. Pull the stakes once the wire is off.

A 24-inch bolt cutter snips thick guy wire and twisted ties cleanly. The long jaws reach the wire without pressing on the trunk.

The mistake that costs most people the tree is prying embedded wire out of the bark. Ripping it out tears a wound much worse than the wire itself.

Gear and next steps

Home Depot sells wide tree straps if the tree still needs support in a windy spot. Wide straps spread pressure far better than wire in hose.

For pulling the steel stakes once the wire is cut, this walkthrough on pulling steel T-post tree stakes covers the rest of the job.

Comments

Popular posts from this blog

Hardware Cloth Guide: Mesh Sizes, Gauges, and Which Build Each One Fits

How to Attach Hardware Cloth to Wood Frames (Staple, Screw & Batten Spec)

How to Attach Hardware Cloth to Metal T-Posts and Pipe Frames (Tie & Clamp Spec)