Spacing T-Post Line Posts on a High-Tensile Fence: Use the Short End of the Range for Steel, and Drive Only to the Anchor Plate

Straight row of steel T-posts along a string line on high desert

Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.

High-tensile wire lets you space line posts much farther apart than barbed wire. Steel T-posts are the exception, and that is where many long runs start to sag.

On a high-tensile fence, steel line posts belong at the short end of the recommended 24- to 48-foot spacing, and a stricter government spec caps metal posts at 14 feet. Drive studded T-posts only until the anchor plate is below the surface.

What the specs say

Virginia Cooperative Extension's guide to constructing high-tensile wire fences gives line post spacing of 24 to 48 feet. It says to use the minimum spacing for steel posts or for wood posts with tops under 3 1/2 inches.

The same guide says studded steel T-posts need to be driven only until the anchor plate is beneath the surface. Line posts can go in with a manual driver.

The British Columbia four-strand fence specifications go further for range fence. Metal posts there must be no more than 14 feet apart, at least 6 feet long and 1.25 pounds per foot, and never used for brace assemblies.

Laying out the line

  1. Set and brace the end assemblies with wood posts first.
  2. Stretch a string between the braces.
  3. Pick your spacing, staying at the short end of the range for steel posts.
  4. Mark each post spot with paint and adjust so a post lands on every knoll and dip.

Driving the posts

  1. Stand each T-post on its mark with the studs facing the wire side.
  2. Drive it plumb, checking with a level every few blows.
  3. Stop as soon as the anchor plate disappears below grade.
  4. Sight down the line every few posts so the row stays straight.

A T-post driver keeps every post at a consistent depth. Its weight does the work so your swing stays smooth down a long line.

The classic mistake is stretching steel posts to the wide spacing a wood fence can handle. The wire bellies between posts and the T-posts lean toward the pull.

Gear and next steps

Tractor Supply carries T-posts by weight per foot, so check the label against your spec. Buy a few extra for dips you will find on the walk.

For the wire that goes on next, this guide to clipping welded wire to T-posts shows how to fasten to the studs.

Comments

Popular posts from this blog

Hardware Cloth Guide: Mesh Sizes, Gauges, and Which Build Each One Fits

How to Attach Hardware Cloth to Wood Frames (Staple, Screw & Batten Spec)

How to Attach Hardware Cloth to Metal T-Posts and Pipe Frames (Tie & Clamp Spec)