Splitting Firewood to Stove Width and Stacking It to Season: Cut 16 to 20 Inches, Split Soon After Bucking, and Cover Only the Top

Freshly split stove-length firewood stacked on rails under a top cover

Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.

Firewood does not really start drying until it is split. The stove also needs a set length and width, so the same session should get the wood to size and into a stack that can dry.

Cut bolts about 16 to 20 inches long, or 3 inches shorter than your firebox, and split them to about 2 to 6 inches wide soon after bucking. Stack the wood off the ground and cover only the top. Give it at least six months, often six to twelve, and burn it only after moisture is below 20 percent.

What the firewood guides say

University of Maryland Extension's guide to buying and storing firewood says seasoning really begins after the wood is split, not when the tree was cut. It says to cut pieces 3 inches shorter than the firebox, usually 16 to 20 inches, stack them off the ground, and cover the top of the stack but not the sides.

The Maryland guide says freshly cut firewood can hold up to 50 percent moisture and needs to dry below 20 percent, which takes 6 to 9 months. Wood over 20 percent is harder to light, gives off less heat, and raises the risk of creosote in the chimney.

Penn State Extension's Heating with Wood guide says to split wood to 2 to 6 inches wide and season it 6 to 12 months, to about 20 percent moisture. Its ideal schedule is to cut by April, split after felling, stack by May, and dry at least six months.

Splitting to size and stacking

  1. Measure your firebox and cut bolts about 3 inches shorter than that opening, usually 16 to 20 inches.
  2. Split each bolt soon after bucking, down to about 2 to 6 inches wide.
  3. Stack the splits on rails or pallets so air can move under the pile.
  4. Cover only the top, and leave the sides open so moisture can leave.
  5. Keep this year's stack separate from already-seasoned wood.

A 6-pound splitting maul is the right daily tool for turning a pile of bolts into stove-width splits. Clear wood pops in a swing or two, and the same head will start a wedge on the knotty pieces.

The classic mistake is stacking unsplit rounds under a tarp that hangs down the sides. The wood stays wet, and you still have all the splitting to do later.

Gear and next steps

Home Depot sells moisture meters, pallets, and a simple tarp or rack cover. Test a freshly split face, not the dry outer skin, before you burn a piece.

With the stack in place, this walkthrough on raking pine needles out of the 5-foot ember zone covers keeping the ground around the house clear of fuels.

Comments

Popular posts from this blog

Hardware Cloth Guide: Mesh Sizes, Gauges, and Which Build Each One Fits

How to Attach Hardware Cloth to Wood Frames (Staple, Screw & Batten Spec)

How to Attach Hardware Cloth to Metal T-Posts and Pipe Frames (Tie & Clamp Spec)