Using the Rope-Pull Lopper Head and Curved Saw on a Manual Pole Pruner: Lopper for Wood Up to About 2 Inches, Saw for the Rest
Disclosure: This post contains affiliate links. If you purchase through these links, we may earn a small commission at no extra cost to you.
A pole pruner with both a rope-pull bypass lopper and a curved saw is two tools on one pole. The clean cut comes from picking the right head before you start pulling.
Use the rope-pull bypass lopper head for high, smaller branches, generally up to about 2 inches, and switch to the curved saw for larger wood. Stand on the ground, work from the side, and keep the pole away from utility lines. A clean, one-pull cut beats a torn stub.
What the equipment guides say
Iowa State University Extension's guide to pruning equipment describes a pole saw as a saw blade on a long pole, and a pole pruner as a stationary hook and hinged blade operated by a rope. It says both are generally used to cut branches up to 2 inches in diameter, and that the work should be done from the ground whenever possible.
Oklahoma State University Extension's pruning equipment and safety guide says pole pruners may have a saw, a hooked lopper, or both, with the lopper used on smaller branches and the saw on larger ones. It says not to work directly overhead, to wear a hard hat and safety glasses, and never to prune within 10 feet of a utility line.
Picking the head and making the cut
- Hook the lopper head over a branch that is about 2 inches or smaller, and pull the rope in a smooth stroke to the collar.
- If the blade pinches or the wood is stouter than a clean rope cut, switch to the curved saw.
- For a heavier limb, undercut first with the saw, then finish from the top so the bark does not strip.
- Stand to the side, not under the branch, and reset your feet every time you extend the pole.
- Stay at least 10 feet from utility lines, and stop if you cannot control the head.
A manual pole pruner puts both heads on an extendable fiberglass pole, so you can lop a twig and saw a 2-inch limb without climbing. Extend it only as far as the cut still feels controlled, even if the pole can reach about 27 feet.
The classic mistake is forcing the lopper through a thick limb until the rope stretches and the hook twists the branch. The cut tears, and the head can kick.
Gear and next steps
Harbor Freight and Home Depot both sell replacement ropes and a file or stone to keep the lopper sharp. A dull hook crushes more than it cuts.
Once a limb is down, this walkthrough on taking down a 3-inch yard tree limb with a folding pruning saw covers the three-cut method for wood you can reach by hand.

Comments
Post a Comment